The MediaTek MT6360 is a highly integrated intelligent power management IC that includes a single-cell Li-Ion/Li-Polymer switched-cell battery charger, USB Type-C and power delivery (PD) controllers, dual Flash LED current sources, RGB LED drivers, two step-down converters, and six LDOs for portable devices. The switching charger integrates a synchronous PWM controller, power MOSFETs, input current sensing and input current regulation, high-precision voltage regulation, and charge termination circuitry. In addition, the charging current is regulated by means of an integrated sensing resistor. It also supports USB On-The-Go (OTG). USB Type-C and PD controllers are compliant with the latest USB Type-C and PD standards. It integrates a complete Type-C transceiver, including Type-C termination resistors, Rp and Rd, and enables USB Type-C detection, including connection and orientation. It also integrates the physical layer of the USB BMC power delivery protocol, allowing for power delivery and role reversal. The BMC PD feature fully supports alternate modes on the USB Type-C standard.

1. RGB LED driver ‒ 3-channel LED driver ‒ Sink current for 3 RGB LEDs: 24mA/channel ‒ Flash mode frequency range: 0.125Hz to 256kHz ‒ RGB_ISINK1 for CHG_VIN Power Good Indicator ‒ Register mode, flash mode, and breath mode are supported 2.Moonlight LED driver ‒ 5 to 150mA absorptive LED drivers ‒ Linear mode control ‒ 5mA/step 3.Buck ‒ 2-channel bucking ‒ 0.3V to 1.3V Programmable Voltage Translation Slew Rate ‒ Output current capability: 4A ‒ Sequential shutdown delay time selection is supported ‒ Input Undervoltage Lockout (UVLO) ‒ Thermal shutdown and overload protection 4. Flash LED driver ‒ Synchronous boost dual flash LED driver with dual independently programmable LED current sources ‒ Flashlight mode current: from 25mA to 400mA in 12.5mA steps per channel ‒ I2C Programmable Flash Safety Timer from 64 ms to 2432 ms at 32 ms per step ‒ Flashing LED1/LED2 Short-circuit protection and output short-circuit protection ‒ TXMask protection using DedicatedFL_TXMASK pins ‒ Shared charger/OTG as power stage ‒ Stand-alone torch bypass MOSFETs from VSYS ‒ Gated mode current: 50mA to 1.5A per channel in 12.5mA steps or 25mA to 750mA in 6.25mA steps for total current up to 2.5A Typical Application Circuits: